© Advanced Labelling Limited July 2008
-
18
-
LabelStation Pro Series Set Up Manual July 2008
•
Reset the printer by turning the
POWER
switch off and on.
3.1.5. Printer
Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults. The only one
exception is ribbon sensitivity, which will not be restored to default.
Printer initialization is activated by the following procedures.
1. Turn off printer power.
2. Press the FEED button and then turn on power. The LED will become red, orange, green
with 5 blinking (around 5 seconds) for each colour.
3. Release the FEED button when LED becomes green (within the 5 flashes)
The LED color will be changed as following pattern:
Orange
Red (5 flashes)
Orange (5 flashes)
Green (5 flashes)
Solid green
Printer configuration will be restore to defaults as below after initialization.
Parameter Default
setting
Speed
127 mm/sec (5 ips)
Density 7
Label Width
4.25” (108.0 mm)
Label Height
2.5” (63.4 mm)
Sensor Type
Gap sensor
Gap Setting
0.12” (3.0 mm)
Print Direction
0
Reference Point
0,0 (upper left corner)
Offset 0
Tear Mode
On
Peel off Mode
Off
Cutter Mode
Off
Serial Port Settings
9600 bps, none parity,
8 data bits, 1 stop bit
Code Page
850
Country Code
001
Clear Flash Memory
No
Note:
When printer initialization is done, please calibrate the gap sensor again – see 5.1.2 Gap
Sensor Calibration Utility.