Shock Dyno
Version: 1.0.23241
Page 22/62
8.3.
Configuration
After launching the application for the very first time, follow the steps below to configure the
initial settings:
1.
Keep the Dyno powered off.
2.
Launch the application and go to the Settings page.
3.
In the General Settings tab, select the Default Data Catalog by clicking on the Select button
(Figure 16 – Step 1). This catalog will be used to store test data files.
Figure 16
4.
Select Communication Mode by clicking on the drop-down menu (Figure 16 – Step 2):
a.
Wireless communication—Wi-Fi network is required in the workshop (no LAN
connection is needed). Make sure the router is relatively close to the Dyno, and
there are no obstacles to cause interference to the signal.
b.
USB cable—the cable will have to be connected at all times during operation with
the Dyno.
5.
Go to the Dyno Settings tab.
