La Pavoni DAYTONA 1-POWER, Технические инструкции

Страница: 53 / 82

383033GB Pag. 53 November 2003
Remove the technician or owner’s card, and insert the card to be programmed.
Once the card to be programmed has been inserted, the display will automatically show the machine device code:
CARD CODE
X XXXX
Insert the code relevant to the card to be programmed, (the card code might be different from the device code).
To insert the card code, proceed as follows:
The blinking
X number indicates the first figure of the code to be modified:
Press the key N°13 (1x) or N°14 (2x) to modify the figure.
Press the key N°16 (3.4.5…X) to confirm the modification.
Press the key N°15 (gost2) to enter the next level without saving the modification carried out.
Press the key N° 12 (gost1) to return to the previous environment and/or exit.
After having modified the first figure and confirmed the operation, the display shows:
CARD CODE
X X XXX
Where the blinking
X number indicates the second figure to be modified, etc. etc.
Repeat the above operations for all the other figures.
WARNING:
a) If the card is new, the card code to be entered is 21845 .
b) If the card has already been used in another device, you must necessarily remember the card code previously
programmed; the operator has to remember the programmed code number of the card. Without the card code the
card cannot be used.
Once the card code has been entered, the display shows:
a)
SYSTEM PROGRAMMING
FUNCTION OVER
Remove the credit card, the display shows:
SYSTEM PROGRAMMING
INSERT CARD
XXXXXXXX
Where XXXXXXX indicates
TECHNICIAN
if the card inserted to enable the programming of waiter’s card was the technician’s
OWNER if the card inserted to enable the programming of waiter’s card was the owner’s
Insert the requested card, the display shows:
SYSTEM PROGRAMMING
SMART CARD PROGRAMMING
WARNING:
The credit amounts to zero, to insert the credit amount follow the proper procedure (see chapter).
b)
SYSTEM PROGRAMMING
CARD CODE
NOT VALID
This message is displayed if the inserted card code does not correspond to that of the card.
Remove the card to be re-programmed, the display shows:
SYSTEM PROGRAMMING
INSERT CARD
XXXXXXXX
Where XXXXXXX indicates
TECHNICIAN
if the card inserted to enable the programming of the waiter’s card was the technician’s
OWNER if the card inserted to enable the programming of the waiter’s card was the owner’s.
Insert the requested card, the display shows: