La Marzocco linea mini, Руководство по эксплуатации

Страница: 17 / 140

EN
17
3. Cleaning the body.
Wipe the stainless steel surfaces with a
soft, non abrasive cloth in the direction of
the glazing marks, if any. Do not use any
alcohol or solvents whatsoever on painted,
imprinted, or plastic parts in order not to
damage them. Clean the side panels using
a soft cloth. Clean only with a damp soft
cloth.
4. Cleaning the hot water and steam nozzles.
Steam nozzles must be cleaned
immediately after use with a damp cloth
and by producing a short burst of steam
so as to prevent the formation of deposits
inside the nozzles themselves, which
may alter the flavor of other drinks to
be heated. Hot water nozzles must be
cleaned periodically with a damp cloth. If
milk residue is present on the steam wand,
soak the tip in a container of hot water,
then it will be possible to wipe the tip
clean. Repeat process if residue remains.
NOTE:
This cleaning schedule is based
upon a moderate to average use (20-
300) cups per day. If machine use is less
than moderate then this schedule may be
adjusted accordingly.
Cleaning (Periodic)
1. Draining boilers:
Both the Integrated
brew group and the steam boiler may be
drained and refilled to reduce the chance
of mineral deposits build up on the inside
walls of the inside surfaces. Additionally
this draining process can be used to
remove water that has a bad odor or taste.
Drain the steam boiler:
Turn OFF the
machine. Remove the rear panel assembly.
Locate the ball valve on the bottom right
side of the machine. Hold the ball valve
with one tool and remove the brass cap on
the end of the valve. Move the espresso
machine close to a waste drain and tip
machine at an angle to point the valve into
the waste drain.
Drain the Integrated brew group:
Turn OFF
the machine. Using adequate protection or
an appropriate tool, loosen the expansion
valve until water begins to flow freely.
Then open the ball valve on the left side.
2. Clean the water reservoir:
The water
reservoir needs to be cleaned periodically
to ensure that no algae forms on the inside
surfaces. To clean, first remove the water
reservoir from the machine. Disconnect the
clear plastic water intake hose. Unscrew
all screws from the cover to separate the
parts. Wash all parts with warm soapy
water. All parts are dishwasher safe.