EN
14
135 mm
5,3 in.
100 mm
4 in.
POSITION OF THE HIGH LEGS MACHINE
535 mm (2 groups)
21 in. (2 groups)
735 mm (3 groups)
29 in. (3 groups)
70 mm
2,8 in.
195 mm
7,7 in.
HERE THE POSITION
OF THE DRAIN TUBE
HERE THE POSITION OF THE POWER CORD
185 mm
7,3 in.
FROM
∅
80 TO
∅
100 mm
FROM
∅
3 in. TO
∅
4 in.
HERE THE POSITION WHERE WE
SUGGEST TO MAKE THE HOLE
ON THE TABLE
96 mm
3,8 in.
440 mm
17,3 in.
92 mm
3,6 in.
420 mm
16,5 in.
HERE THE POSITION OF THE
WATER INLET HOSES
320 mm
12,6 in.
350 mm
13,8 in.
975 mm (4 groups)
38,4 in. (4 groups)
Fig. 2 - Installation guide
1) Installation on the counter
The image below shows the recommended method to drill the hole on the counter.
VERIFICARE LE MISURE PRIMA DELLA STAMPA IN PRODUZIONE
2) Accessories
In order to proceed with installation, it is
necessary that the following are available:
• Pipes carrying drinking water with a
3/8”G (BSP) end connection; (3/8”
Compression for USA and Canada)
• Electrical Supply according to the
specification of the espresso machine
purchased:
• Single/Three phase 220VAC - 50/60
Hz electrical connection with ground,
protected socket and approved
interlock switch
• Single phase 200VAC - 50/60 Hz
electrical connection with ground,
protected socket and approved
interlock switch
• Three-phase, 380VAC - 50 Hz
electrical connection with neutral +
ground, near the bench on which the
machine is installed and terminating
in a suitable protected fivepole socket
equipped with an approved interlock
switch
• Waste water drain system.
3) Water test kit
In order to enable you to check if your water
supply is within the suggested ranges, La
Marzocco machines will be equipped with
two units of a quick water test kit (see image
below) including 6 test-strips and instruction
cards.
