![background image](http://html1.mh-extra.com/html/l-b-white/premier-ts040/premier-ts040_owners-manual-and-instructions_3223177015.webp)
Premier Ductable Heater
Owner’s Manual • Premier Ductable Heater
15
Start-Up Instructions
For initial start-up after heater installation, follow steps 1-4.
1. This heater is wired with a ground connection for your
protection against an electrical shock hazard. The heater
must be connected directly to a properly wired and
grounded electrical supply.
A. Heat Mode Operation
a. Open all manual fuel supply valves. Check for gas
leaks using an approved leak detector. The gas con-
trol valve in the heater has a manual shut-off feature
incorporated into the valve assembly. Ensure the
indicator on the valve is positioned to ON. See Fig 11.
FIG. 11
b. Push the selector switch to heat. See. Fig. 12.
FIG. 12
c. Set the thermostat above room temperature
-- The fan motor will start
-- Igniter will spark
-- Ignition occurs
d. The thermostat cycles the heater on and off based
on the temperature set point.
(It is normal for air to be trapped in the gas hose on new
installations. The heater may attempt more than one
trial for ignition before the air is purged from the line and
ignition takes place.)
When the switch is set to heat, four status lights (see
Fig.13) will be activated in sequence as specific circuits
are checked by the ignition control. If the heater does not
light, and a status light is off, refer to the troubleshooting
label on the heater’s case or the troubleshooting guide in
the owner’s manual.
FIG. 13
B. Vent Mode Operation
-- Push the selector switch to off,
O
, then to vent
-- Only the fan motor will operate. The igniter will not
spark,nor will ignition occur.
The ventilation feature is used when air circulation is re-
quired. The heater will not cycle on its thermostat setting.
C. Off O
1. Position the switch to midpoint O.
2.
Do not exceed input rating stamped on
nameplate or manufacturer’s recom-
mended burner orifice pressure for size
orifice(s) used. Make certain that the
primary air supply to main burner is open
and free of dust, dirt and debris for com-
plete, proper combustion.