Kyocera 1629298, Инструкции по безопасности и эксплуатации

Страница: 9 / 168

English
9
Single sequential trigger
• To actuate the fastenerer, depress the safety brack-
et against the workpiece, and pull the trigger.
• To actuate the fastenerer again, you will need to re-
lease the safety bracket fully and release the trigger
before repeating the above procedure.
Bump fire
• Activate the trigger, bump the safety bracket
against the workpiece, and a shot will be fired.
• To actuate the fastenerer again, you will
need to release the safety bracket fully before
repeating the above procedure.
Switchable trigger
• The tool can be fitted with a switchable
trigger. This allows you to switch between single
sequential fire and bump fire. Depending on the
tool model, this can be done either by:
∙ pushing the switch button back or forth.
∙ pushing the switch button outwards and twisting
it.
∙ pushing the black switch button stud inwards and
displaceing the switch shaft.
Clearing a jammed fastener
• In the case of fastener jam, disconnect the air sup-
ply before you perform any actions. Point the tool
away from yourself or anyone else.
• Press down the magazine lock (D) and swing the
magazine door open (C).
• Insert a mandrel into the nose (B) to drive the
jammed nail up and into the nose bore. (Fig. C).
• Remove the jammed fastener with needle-nose
pliers or similar type of tool (Fig. D). Do not use your
hand to remove the fastener.
• If you failed to remove the jammed fastener by
above method contact your local TJEP dealer.
Maintenance instructions
General maintenance
• The employer and the operator are responsible for
assuring that the tool is kept in safe working order.
Furthermore, only authorized TJEP service per -
sonnel or TJEP distributors shall repair the tool and
must use parts or accessories that are supplied or
recommended by Kyocera Unimerco Fastening.
• Keep the tool in clean condition at all times. Wipe
off grease or oil with dry clean cloth to prevent
accidental drop of the tool.
• Use TJEP lubicator in the air plug (H) of the tool at
least twice a day (depending on frequency of use).
• Avoid any use of solvent base cleaner to clean the
tool, as certain solvent will damage or weaken the
composite parts of the tool.
• All screws and nuts should be kept tight and undam-
aged. Loose screws may result hazard situations
and cause severe personal injury or parts breakage.
• It is recommended to use a filter and regulator on
the compressor.
• On a daily basis empty the compressor tanks for
water.
• NEVER use a tool if there is any doubt.
Cold weather
• When operating the tool in temperatures near and
below freezing, the moisture in the air line may
freeze and prevent the tool from operating.
• Reduce the air pressure to 80 psi (5.5 bar) or less.
• Remove all fasteners from the magazine.
• Connect the compressor and blank-fire the tool, as
slow speed operation tends to warm up the moving
parts.
Storage
• When not in use for an extended period, apply a
thin coat of lubricant to the steel parts to avoid rust.
Do not store the tool in a cold weather environment.
When not in use, the tool should be stored in a
warm and dry place. Keep out of childrens reach.
Disposal
• Disposal of the tool must be carried out according to
the instructions given by the local authorities.