Kymera Body Board, Руководство пользователя

Страница: 22 / 28

Unpacking and checking your Kymera
Store your board with the rear hatch open to ensure that any remaining moisture has an opportunity to escape
3. Store your board anywhere you like either laying down on shelves or standing on its tail in the corner of your garage or even your spare
room!
4. If you are concerned about residual water draining from the board you may like to sit it on a towel or with the chamois under the drain
plug.
Extended Storage
It is important to dry out the board before storage for any extended periods of =me to ensure your board doesn’t become mouldy or aFract
mosquitos
Aber draining water from the board, stand the board on its tail or lay it with the nose higher than the tail to get most of the water to exit the
board via the self-draining plug at the rear of the board.
When the plug stops expelling water, lay the board flat on the ground, a kayak stool or work horse. Water will pool near the front of the board
and use a chamois to remove any remaining water.
Leave both hatches open aber use and cleaning to allow the board to dry fully.
Any residual salt water, or if the board is stored in a salty environment, creates the risk of rust and corrosion on all metalwork, as with all
vessels, vehicles and motors. It is cri=cal to protect the board with corrosion inhibiters before storing for an extended period where the board
won’t be used and cleaned regularly.
Once the board is fully dry, apply one small squirt of grease into both grease nipples (don’t apply too much grease).
Then, apply Inox or a similar corrosion inhibiter to all of the metalwork in the board, including but not limited to:
1. the whole drive shab
2. the drive shab bearings
3. the motor, front and back
4. all stainless screws and fixtures
Servicing
Properly cleaning and maintaining your Kymera is criTcally important to ensure longevity of the board.
PrevenTon
Do not ride your Kymera in shallow water, water with large amounts of debris (for example, aber heavy rain) or in water with high levels of
par=culate (for example sand or dirt).
Aber each use, remove the baFery and drain the board of water completely. Avoid submerging electronics by =pping the board nose up
allowing water to drain out the rear.
At the end of your day out, hose your Kymera with clean fresh water inside and out. Avoid submerging electronics by =pping the board
nose up allowing water to drain out the rear.
At the end of your day out, clean the cooling lines with clean fresh water using a hose and the supplied cooling line adapter on LOW
pressure (see above).
With the baFery unplugged and removed, ensure that the jet pump and impeller are clean and clear of obstruc=ons. Carefully remove
foreign material, if any.
Page 22