KwiKool
®
BioKool™
KWBIO1411 is equipped with two brass female ½” (NPT)
pipe thread connections located on the lower left corner of the back panel.
Each fitting is labeled for water in or out. Use the proper sized wrench to
connect either hard piping or the optional high-pressure line set, available in
various lengths from the factory, be sure and use a backup wrench on the
mounting bolt of the fitting to prevent the copper tube inside the cabinet
from twisting when making your connections. Apply Teflon tape or pipe
sealant to the thread for a good seal. Water pressure should be limited to 150
PSI maximum and should be between 40° and 85° F. If the water supply is
interrupted or the incoming water temperature is too high, the unit will shut
down and go into an audio alarm and display
HP
on the control. The high
pressure switch is tripped and must be reset by pressing the
HP
reset button
located in the return air compartment, be sure the water supply has been re-es-
tablished to avoid future tripping. For long term use of water-cooled models a
circulating water supply, such as a chilled water plant or cooling tower system
is recommended. Tap water is not an acceptable water source, due to the high
water consumption.
Verify that the source power, phase and breaker size is compatible with your
KwiKool
® serial plate information and that the electrical circuit is dedicated
only for the use of the unit. If you aren’t sure about your power, contact a
licensed electrician. KwiKool
® systems are factory equipped with 8 feet of
power cable sized to meet the power requirement of your system. Extension
power cable is allowed but cannot exceed 25 feet and must be rated to
operate your unit. Units that come supplied with a factory installed plug
require the exact receptacle to match the plug and exact circuit size and
power. Cutting the power plug on your unit will void its warranty.
Water Connection for KWBIO1411
POWER CONNECTION
MAKING CONNECTIONS
Содержание BioKool KBIO1411
Страница 2: ...FAMILY OF PRODUCTS...
