Kwik Lok 086B-100, Инструкция по эксплуатации

Страница: 8 / 72

SECTION II
Operation
P 2.2
B. LOADING A ROLL OF CLOSURES:
1. Cycle the closer until the closures stop
advancing. Avoid cycling the closer more than
necessary when there is no closure in the
closing position. This will avoid a buildup of ink
residue on the closure track.
2. Move the run switch to “STOP” so the
mechanism is properly positioned.
3. When closing with closures, insert the closure
hub into a new roll of closures. Be certain the
closures feed forward from the bottom of the
roll.
When closing with labels, insert the closure hub
so that the label of the closure is right side up
when the closure strip is in the closure track.
4. Install the hub and roll.
5. Open the printer cover and check to see if there
is any ink residue on the bottom of the closure
track within the printing area. Use a soft cloth
or tissue to wipe any ink off the closure track
so the ink will not smear on the underside of
the closure.
6. Remove the masking tape and feed the end of
the strip into the closure track until the first
closure has passed the check and is against
the stop. Close the printer cover.
7. With the Power switch in the ”ON” position,
press the run switch to “RUN”. The closer will
cycle once and move a closure into the closing
position. Remove the first three unprinted
closures by hand. The closer is now ready to
close bags.
C. PREPARING THE PRINTER:
Figure 2.2 & 2.3
(If the machine is a non printer Model, skip to
Part E, CLOSING BAGS)
1. Open the printer cover.
2. Select the print image.
a. For the band printer, rotate the top of the print-
head toward the front of the closer so the
selected type characters can be easily viewed
through the window on the top of the print head.
Slide the selector knob out to select the desired
band and rotate the knob to select the desired
character. When finished, rotate the bandhead
back against the spacer.
b. For the typeholder block, remove the knurled
knob and slide the printer block off the shaft and
spring pin. Place the selected type in the
grooves that are the farthest away from the
holes in the mounting block. For normal viewing
on the closure the bottom edge of the characters
should be toward the middle of the block. Cen-
ter the type from side to side. Replace the block
on the shaft and pin so the type is close to the
ink roll arm. If the type or typeholder block is not
installed correctly, the type will not be inked
properly.
3. Unscrew the knob (Ink roll) and position the ink
roll between the knob and the cam follower.
4. Mate the ink roll to the end of the cam follower
and screw in the knob to secure it. Under most
conditions the ink roll can be left on the printer
until the ink is used up. The ink roll will not dry
out.
5. Close the printer cover.
6. Cycle the printer and discard the unprinted
closures.
086B 02 18