2-4
A Guide to TracVision L3
the appropriate fasteners, two flexible wings allow
the rear mounting bolts to attach to the antenna
baseplate. These may be angled upward to ensure
a secure mounting, as shown in Figure 2-4.
10. Using the mounting plate as a template, drill four
3
⁄
16
" (5 mm)-holes through the roof of the vehicle at
each of the four corners. Temporarily secure the
mounting plate at the corners with rivets or
screws.
11. With the corners secured, use the mounting plate
as a template to mark and drill the remaining
nineteen
3
⁄
16
" (5 mm)-holes through the roof of the
vehicle. Remove plate and clean roof surface. The
dimensions of the baseplate and locations of the
drill holes are shown in Figure 2-5.
12. Place the construction adhesive over all holes. If
using a liquid construction adhesive, apply bead
to mounting plate in a zig-zag pattern.
Figure 2-4
Mounting the Unit on a
Curved Surface
Antenna Baseplate bolts to this
“
wing,
”
which can remain horizontal.
Mounting
Plate Wing
Mounting Plate can be tightened down
to conform to a curved surface.
Figure 2-5
Baseplate Dimensions
