KVH Industries Ka Tri-Americas LNB, Руководство по установке

Страница: 12 / 19

13
Follow the instructions below to reconnect and
dress the cables.
a. Using a 7/16" open-end wrench, connect and
tighten the RF1, RF2, RF3, and RF4 cables to
the LNB exactly as shown in Figure 22 and
Figure 23 . Tighten the RF1 cable first. Then
tighten each of the remaining connectors,
ensuring the wire of each connector contacts
the flat of the previous connector when
tightened.
b. Place the supplied connector plate onto the
LNB, as shown in Figure 24 .
c. Firmly secure the connector plate onto the
LNB by inserting a supplied thin tie-wrap
through the LNB mounting holes (shown in
Figure 23 ).
d. Rotate the LNB assembly to ensure there is no
contact between the connector plate and the
limit switch cable (see Figure 24 ). If there is
contact, adjust the RF cables and connector
plate to maximize clearance. Then retighten
the tie-wrap to resecure the connector plate.
e. Trim and remove the excess tie-wrap length.
Reconnect and Dress Cables
Figure 22 RF Connector Orientation
Figure 23 LNB Cables/Mounting Holes
Figure 24 Connector Plate Mounting
RF1
RF2
RF3
RF4
RF1
Mounting
Hole (x2)
Thin
Tie-wrap
Limit Switch
Cable
Connector
Plate
8