14
f.
Tuck the motor cable and gyro wires between
).
g.
While aligning the end of the cable braid with
the right edge of the motor, tuck the cable
harness between the LNB and motor (see
)
h.
Secure the cable harness to the LNB with the
P-clip you removed earlier, and a supplied
#8-32 screw, washer, and nut (see
).
Ensure the P-clip is mounted on the inside of
the LNB (facing the reflector).
i.
Using a supplied tie-wrap, secure the cable
harness and gyro wires to the LNB, as shown
in
j.
Route the cables around the LNB, as shown
in
k.
Loosely secure the RF cables to the LNB plate,
.
l.
Rotate the LNB assembly and ensure the
cables do not contact the limit switch.
m.
Tighten the tie-wrap securing the RF cables to
the LNB plate (see
).
Continued
Reconnect and Dress Cables
Figure 25 P-clip/Tie-wrap Mounting
Figure 26 Cable Harness/Cable Routing
Figure 27 LNB Plate Tie-wrap
Cable
Braid End
#8-32 Screw,
Washer & Nut
Tie-wrap
P-clip
P-clip
Tie-wrap
Routed
Cables
Cable
Harness
LNB Plate
Tie-wrap
Cables
Limit
Switch
8
