KVH Industries Ka Tri-Americas LNB, Руководство по установке

Страница: 6 / 19

7
d. While holding the LNB assembly, fully
loosen the four #8 hex screws on the front of
the reflector using a 9/64" ball-end hex
wrench (see Figure 9 ).
e. Using needle-nose pliers, extract the four hex
screws.
f. Carefully pull the LNB assembly straight
backward.
g. Using a 3/32" ball-end hex wrench, remove
the two #4 hex screws securing the lower feed
to the motor bracket (see Figure 10 ).
h. Using a 7/64" ball-end hex wrench, remove
the #6 hex screw securing the lower feed/
LNB to the motor bracket (see Figure 10 ).
i. Remove the lower feed/LNB and the lower
feed gasket (shown in Figure 13 on page 9 )
from the motor bracket.
To avoid damage, extract the bracket straight
backward; do not move the assembly from
side to side.
IMPORTANT!
Continued
Remove the Lower Feed/LNB
Figure 9 Hex Screws on Reflector
Figure 10 Lower Feed Screws
#8 Hex
Screw (x4)
#4 Hex
Screw (x2)
#6 Hex
Screw
4