Kverneland CLC PRO, Руководство оператора

Страница: 72 / 98

Adjustments
72
Passive knife skids
Introduction
Use this configuration if:
•
You want a coarser level and surface finish in order to avoid any
risk of surface breakdown.
•
You are working in the autumn and you want to sow in the spring.
•
You are not planning to sow for a long time.
Adjustment procedure
on Actiring and Actipack
Raise the knife skids fully to put them in the OFF position (folded
away).

Loosen the locknut.

Loosen the countersunk screw (A) with the small spanner (B) so
that it protrudes by about 1 cm from its conical housing.

Loosen the locknut on the other side.

Engage the long spanner (C) on the welded nut located on the
lower part, such that the rear rail is supported.

While holding the spanner (C) in position, loosen the countersunk
screw (A) with the small spanner (B) so that it protrudes by about
1 cm from its conical housing.

Swing the rail to the required position (1, 2, 3 or OFF).

Still holding the spanner (B) in position, fully tighten the
countersunk head screw (A).

Tighten the locknut.

Go to the other side to fully tighten the other countersunk head
screw (A). If necessary, use spanner (C) again to adjust the
alignment of the screw to the desired position.

Tighten the second locknut.
Scrapers on Actipack
If using scrapers on the roller:

Set the scrapers to OFF position.

The scraper must not touch the central tube, in respecting a
clearance of 5 (
3/16”
) to 10 (
6/16”
) mm relative to the tube.
\
DANGER
No one should stand close to the tractor’s controls while the rollers
are being adjusted.
A B C