Kverneland CLC PRO, Руководство оператора

Страница: 67 / 98

Adjustments
67
Adjustment of the
rear accessories
Leveling discs
and leveling tines Proceed as follows to adjust the working depth of the leveling discs or
leveling tines.
•
The leveling discs are mounted on rubber springs. This system
ensures that the disc is cleared when it encounters an obstacle.
•
One adjustment rod (A) per section centralizes the adjustment of
the discs and the tines.

Raise the machine.

Turn the adjustment rod (A) using the 27 open-end spanner.

Adjust the discs so that they touch the ground without penetrating
it. This is to ensure surface leveling only.

Test and then correct the setting depending on the quality of
leveling obtained.

Check the length of the tie rod; this should not be more than 520
mm (
20
1/2
”
).
→
The adjustment is correct when the soil is level with no tine marks
and no disc marks.
Edging disc or edging leveling tine

Remove the pin which locks the side adjustment shaft (B).

Remove the side adjustment shaft.

Adjust the side position of the exterior disc or the exterior tine.

Position the adjustment shaft.

Insert the adjustment shaft locking pin.

Test and then correct the adjustment if there are any ridges of earth
outside the area worked.
\
WARNING
Keep at a safe distance when changing the settings.
Always keep a safe distance from the machine when adjusting
settings. Failure to follow this instruction could result in serious
injury, even death. In particular, there is a risk that your legs could
be crushed.
A
B