Kval Acro-HD, Руководство по эксплуатации и обслуживанию, Страница: 34 / 64

Run the Acro-HD
2-12
KVAL Acro-HD Operation/Service Manual
.
Note:
If at start-up , the first press of the pedal initiates a warm-up period. This period
typically lasts a few minutes.
Note:
For greater control, tap the foot-pedal to raise the operate the door pivot in small
increments.
7.
Press and hold the
Door Insert
Up foot pedal to
raise the light insert table into its free floating
position from the fixed position.
Note:
When installing the light, the screws need to
be on the inside of the door for security
.
8.
Center the light with-in the cut-
out.
9.
Press and hold the
Door Insert
Up
pedal a second time to raise
the light into the cut-out.
Note:
For greater control, tap the foot-pedal to raise the light in small increments until
the light is aligned with-in the cut-out.
10.
Fasten the light with-in the opening.
Note:
If attaching a frame to the door, go to “Using the Frame Alignment Lifts” on
page 2-13 , if not continue with next step.
11.
Press and hold the
Door Insert Down
pedal to lower Door Light Insert Table to the
free floating position.
12.
Press and hold the
Door Insert Down
pedal a second time to lower Door Light
Insert Table to the fixed position.
13.
Press and hold the
Door Pivot Up
pedal to
bring the clamps into position.
14.
Press and hold (or tap) the
Door Pivot Up
pedal a second time to clamp the door.