Section 6--Testing Procedures
6.5
6.5.0. Stationary & Opposite Direction Moving Modes
1. Press the MODE switch, placing the Eagle II in the
stationary mode (both direction antenna/mode indicators
should be on). Use the remote control to change to the
desired antenna. If the unit is displaying "Hld" in the
TARGET window, depress the HOLD switch on the
front panel to place the unit in a transmitting mode.
MODE
Select
Stationary
or
FRNT
REAR
Select
Antenna
2. Depress and hold the RANGE (up) switch until 6 is
displayed in the PATROL window (maximum range).
After releasing the RANGE switch, the "rnG" display
will remain for 2 seconds then the displays will return to
normal operation.
3. If the antenna label reads “DCM”, momentarily press
the TEST switch to enter the TEST mode. The TEST
indictor will be flashing while in the TEST state. The
radar system will remain in the TEST state for 30-
seconds. Note: pressing the TEST switch while the unit
is in TEST mode will take the unit out of TEST mode
immediately.
4. Lightly strike the lower speed (30 MPH, 35 MPH, or 45
km/h) tuning fork on a hard, non-metallic surface. Place
and hold the tuning fork approximately 1 inch in front of
the antenna.
5. Verify that the TARGET speed displays the same speed
as the tuning fork (30, 35, or 45).