Section 3—Inspection & Mounting
3.7
4. Position the antenna cable behind the rear seat and under
the rear floorboard, then route up to the logic unit and
connect. This method of mounting will minimize the
antenna from moving around in the vehicle should it
break loose in an accident. It should also prevent
anyone from using the cable as a weapon against the
officer.
5. Position the antenna parallel to the ground and straight
down the roadway.
3.2.4. Speedometer Pulse Cable Installation
1. The speedometer pulse cable has a two-conductor plug
at one end and no plug at the other end. The plug
connects into the “SPDOMTR” connector on the rear
panel of the Eagle II
.
2. The bare end of the speedometer pulse cable will be
connected to the patrol vehicle’s electrical speedometer
input cable using the splice connector provided. Due to
the vast number of models, makes and years of vehicles,
we have moved access to specific vehicle diagrams
online, where information can be better maintained and
distributed.
Installation details can be accessed at:
http://www.kustomsignals.com
(select: radar fixed mount)
For information on connecting the TruTrak cable, refer
to the Kustom website above. For information regarding
motorcycle mounts, refer to instructions in the mount
kits.
NOTE: Only the inner conductor of the speedometer pulse
cable is used. The outer shield is not connected.
