Kuppersbusch KD 3700.0, Руководство по обслуживанию

Страница: 15 / 18

Service Manual 15
For internal use only
10. Removing the motor block
The hood must be disconnected from the mains power supply before it is cleaned or
before any maintenance work is carried out.
1. Remove the connections of the two lamps (Fig. 2).
2. Press the two clips on the side and take out the lamp block
(Fig. 3).
3. Remove the metal frame after the four screws A have
been removed (Fig. 4).
4. Loosen the two knurled screws (B) but do not remove
them (Fig. 5).
5. Take out the control element block (Fig. 6).
6. Take off the bottom decorative pipe after the four screws
(C) have been removed (Fig. 7) and pull it out downwards.
7. Pull out the outgoing air tube though the opening at the
back (Fig. 10).
8. Remove the four nuts and the four washers and take the
motor block (E) off the bottom structure (F) – Fig. 11.
9. Remove the four screws (G) which hold the motor block
(Fig. 12).
10. Disconnect the contacts (Fig. 13) and remove the motor
block.
Fig. 10
Fig. 11
Fig. 12
Fig. 13