42
EEB 9800.0
Knobs
Clean the knobs with a weak solution of detergent and warm water, using a
damp cloth or a soft sponge.
Removing and refitting the oven door
Removing the oven door
– Open the oven door as
wide as it will go.
– Fold up the clamps on the
door hinges.
– Take hold of the oven door
on both sides and close it
slowly. When the oven door
is about half-closed, the
hinges will fall out of the
catches.
The oven door can now be
removed.
Reassembling the oven door
– Take hold of the oven
door on both sides and
push the hinges into
the relevant holes on
the oven.
– Slowly open the oven
door until it is fully
open.
– Fold down the clamps
on the door hinges.
– Close the oven door.
Removing and refitting the side racks
Removing the side racks
.
– Undo the screws.
– Take out the racks.
Refitting the side racks
– Insert the side racks and
screw into place in front.
Folding heating element down/up
Folding heating element (top heat/grill) down
– Open lock and fold
heating element down.
Folding heating
element up
Fold heating element up
and close again with the
lock.
Regenerate the ökotherm
®
catalyst
The ökotherm
®
catalyst scrubs the grease particles and odour arising when
roasting in hot air convection mode. The catalyst cleansing capability is usually
adequate. In rare cases of very intensive roasting of very large amounts of
food grease particles may settle on the catalyst. Next time you use hot air
convection, e.g. for baking a pizza, the deposits will be disposed of over time.
Should you feel the catalyst cleansing effect has weakened (e.g. if there is a
strong odour), the catalyst can be regenerated by removing the fatty deposits:
– Select the programme Hot air convection
B
.
– Finally, touch the Rapid heating sensor
J.
– Set the temperature to 290 °C and cooking duration
u
to 60 min.
– Touch the sensor key
j
.
