KUHN GA 4311 GM, Руководство по сборке и эксплуатации

Страница: 12 / 40

- 10 -
ASSEMBLY INSTRUCTIONS
To reduce bulk when shipping the machine, some parts have not been fitted to the machine.
1° FITTING FRONT AND REAR GUARD HINGES
- Assemble rear guard hinges (A) to beam (B) using 6 hexagonal bolts (C) (M 12 x 55), 12 conical spring washers
(M 12) and 6 self-locking nuts (M 12) (photo 1). Do NOT tighten. Stick the 2 red reflectors (D) on the hinges (A)
(photo 3).
- Fit the connecting bar (F) on rear hinges (A) using 2 hexagonal bolts (G) (M 12 x 35) and 2 self-locking nuts (M
12). Torque to 8.5 daNm (62 ft.lbs) (photo 1).
- Now tighten the 6 bolts (C) to a torque of 12.5 daNm (92 ft.lbs)
- Fit front hinges (H) to beam (B) using 8 hexagonal bolts ( I ) (M 10 x 35) and 8 self-locking nuts (M 10) (photo 2).
Do NOT tighten .
2° FITTING GUARDS
- At the front of the machine fit each guard (J) on front hinges (H) by means of a roll pin (K) (diameter 10 x 45) with
washer (E) (diameter 30 x 42 x 2,5) (photo 2). The right guard is fitted with mounting lugs for the air spring (N)
(photo 4).
- At the rear of the machine fit guards (J) on rear hinges (A) and at the same time fit levers (L) using 2 roll pins (M)
(diameter 10 x 55) as shown on photo 3.
- Now tighten the 8 hexagonal bolts (
I
) to a torque of 5 daNm (37 ft.lbs) (photo 2).
- Fit the air spring (N) by attaching it at (O) to the rear right hinge (A) using a flat washer (diameter 9 x 18 x 1.5)
and a split pin (diameter 4 x 22) and also to the right guard (J) in the raised position using hexagonal bolt (P) (M
8 x 30) and self-locking nut (M 8) (photo 4).
After assembly, make sure each safety guard locking system works correctly.