KUHN FC313 RF, Руководство оператора

Страница: 52 / 72

Mower conditioner
50
FC313 RF
Maintenance and storage
After the first 10 hours of use
Cutterbar draining and refilling
From the transport position:
- Using two wedges of different height, rest the
cutterbar higher on opposite side of drain plug.
- Remove the inner skid shoe (1) on drive side.
- Place a container with a capacity of at
least 3 L (0.8 US gal) under plug.
- Remove filler plug (2) and its washer.
- Remove drain plug (3) and its washer.
- Allow oil to drain completely.
- Wait for dripping to stop.
- Clean and reinstall drain plug (3) and its washer
(replace them if necessary).
- Pour the correct oil quantity and quality through the
opening of the filler plug.
- Clean and reinstall filler plug (2) and its washer.
- Reassemble the unit.
Before draining oil, operate the cutterbar for a
few minutes so that the oil warms up.
The cutterbar is lubricated with 2.25 L (0.6 US gal) of SHELL extreme-pressure gear oil with viscosity
grade SAE 80W and API grade GL4.
When draining and refilling, it is recommended to use either a mineral base oil with viscosity grade
SAE 80W and API grade GL4, or a synthetic base oil, type PAO (Poly-Alpha-Olefins) with a viscosity
grade equivalent to SAE 80W.
In certain countries SAE 80W GL4 oil may not be available. In this case a GL4 or GL5 grade
SAE 80W90 oil is an acceptable substitute for GL4 SAE 80W oil.
Never use an oil of viscosity SAE 90 in the
cutterbar.
Attach and lock safety chains on the highest
tractor attachment position.
2
1
3