- 21 -
Note
: -
Slide rod (9) in place so that the holes for roll pins (14) are located on the gearbox side
(photo 16).
- Attach front and side curtains to one another with 2 straps (15) (photo 14).
- Attach springs to their respective anchorage points with the small chains (16 and 17) (photos 13, 16 and
fig. 15) and
close the eyelets
.
12° Attaching rear curtain
Remove both end bolts (23) (photo 19). Install the rear curtain (24) (red stripe visible from the rear) under hood (25)
with bar (26) and 5 cup square bolts (23) (M 10 x 20), 5 plain washers (27) (dia. 11 x 24 x 2) and 5 self-locking nuts
(M 10) (28) (see photo 18 and fig. 19).
The lower hitch pins should stay parallel to the ground when the machine is parked. If this
is not the case the lift cylinder should be bled in extended position.
11° Attaching swath shields
Attach both swath shields (18) with axles (19), plain
washers (20) (dia. 16.5 x 25.5 x 4) and roll pins (21)
(dia. 5 x 30) (fig. 17).
Install lock handles (2) with 2 cup square bolts (M
10 x 35), 2 washers (diameter 36 x 11 x 2) and 2 self-
locking nuts (M 10) (photo 18).
Then tighten the 4 self-locking nuts (M 10) on the swath
shields.
