Transport restraint of the main e-chain: blue
tape is strapped around the chain an fastened to
the top cover.
Transport restraint of the extruder head: the
extruder head is cushioned with air cushion foil
and strapped to the right X-end with blue tape.
The doors are held close by blue tape at the top
and lower edge.
The touchscreen is packed in air cushion foil.
A cardboard frame supports the print table.
Connections
After setting the apparatus up it must be connected to the power supply and the data network.
Set the power supply main switch at the back of the 3D Printer to <0> (OFF).
1.
Unpack the supply cable and connect it to the mains plug at the backside.
2.
Connect the Schuko plug to a 230 V socket.
3.
Connect the HT500 to your data network by plugging the network cable into the RJ45 ethernet
4.
plug. Your network must provide DHCP IP address management and should be connected to the
internet (to enable the printer to fetch current time signal via Network Time Protocol (ntp)).
