experimental usage and should only be used
with a max. extrusion speed of 20mm/s for a
start. Adjust the extrusion speed stepwise until
optimized for your needs.
The 0.25mm nozzle is for filigree, thin walled
extrusions. Do not exceed an extrusion speed of
35mm/s since the material throughput will not
suffice for higher speeds.
Print table and print bed
No. Description
1 Elevator assembly
2 Removable 1.8mm PEI print bed
3 Bulldog clamp
4 Heated print table
The print table is mounted on the crossbeams of
the elevator assembly which is positioned
accurate to the millimeter in Z-direction in its
useful operating range of 280mm by a
spindle
drive
.
The print table itself consists of an aluminum
sandwich panel with a silicone rubber heating
pad that provides temperatures of up to 130°C,
providing an even temperature distribution and
ensuring optimal adhesion throughout the
printing process.
Print table and print bed fastened with four
bulldog clamps
No. Description
5
Set screws of the spring-mounted 3-point
leveling support
It rests on three springs lockable with set screws
for an even and accurate leveling since a
precisely adjusted distance between print bed
and nozzle tip is vital for the print bed adhesion
an the print results.
The semi-automated leveling process is
described in the
Operating Manual
. Additional
information on leveling can be found in the
Knowledgebase
.
Print jobs are executed on the removable print
bed laid on the print table and fixed with four
bulldog clamps at the corners. This fixation
allows the use of print beds of different
thicknesses.
3-point leveling support
