Do not use solvents inside the build chamber. Solvent fumes may damage printer components
or dissolve printed objects.
Additional information
Your network must provide DHCP IP address management and should be connected to the
internet to enable the 3D Printer to fetch current time signal via Network Time Protocol (ntp).
When printing large objects with high demands concerning dimensional accuracy and close
tolerances, it is advisable to let the 3D Printer cool down for at least 30 minutes after finishing
the print job to minimize warpage and to ensure the best possible results.
Small gas bubbles appearing in the water cooling system after the initial commissioning are not
unusual. Due to the heating process the coolant may degas. This should disappear within the
first few operating hours. Otherwise, it is necessary to fill up the cooling system. You will find
further information in the complete manual at
.
Overview
touchscreen and power-on button at the front