KUHL Quantron E2, Оригинальное руководство пользователя

Страница: 51 / 108

Operation of the Quantron E2
45
4
4.5.6 Calibration
In this menu, you can determine the flow factor based on a calibration and save
it in the control unit.
Carry out a calibration:
before spreading for the first time.
if the fertiliser quality has changed significantly (moisture, high dust content,
cracked grain).
if a new fertiliser type is used.
The calibration must be conducted with engaged PTO at a standstill or during
travel over a test section.
Remove both spreading discs and move the drop point to the calibration po-
sition (DP 0).
Entering the working speed:
1. Switch from the Fertiliser settings menu to the Calibration start menu.
2. Enter the average working speed.
This value is required for calculating the slide position during the calibration.
3. Enter the new value in the input field using the arrow keys :
Arrow up : Value increases.
Arrow down : Value decreases.
See also chapter 4.11.2: Input of values using the cursor keys, page 89
Figure 4.19: Working speed menu
4. Confirm the input by pressing the enter key .
The new value is saved in the control unit.
The operating screen prepare calibration will appear on the display.