KUHL ALTOR 11050, Инструкция по эксплуатации

Страница: 34 / 46

34
MAINTENANCE
BEFORE CARRYING OUT ANY MAINTENANCE, SERVICING OR REPAIR
WORK OR WHEN INVESTIGATING THE CAUSE OF A FAILURE OR
MALFUNCTION, YOU MUST SWITCH OFF THE ENGINE, LAY THE MACHINE
DOWN, REMOVE THE IGNITION KEY AND WAIT FOR THE MOVING PARTS
TO COME TO A COMPLETE STANDSTILL.
Before proceeding with any maintenance work on a machine in the raised position,
prop up the machine with an appropriate support.
WHEN CLEARING A BLOCKAGE OR REPLACING A WORKING PART, WEAR
PROTECTIVE GLOVES AND ONLY USE APPROPRIATE TOOLS.
BEWARE! NEVER PASS BETWEEN THE BEATER BARS TO ACCESS THE
TURBINE.
To avoid environmental contamination, it is forbidden to throw away or dump any
type of oil, grease or filter. Hand them over to collection firms.
Before carrying out any operations on the electrical circuit, disconnect the power
source (tractor charging circuit or battery).
Any protective devices liable to wear should be checked regularly. Replace them
immediately if they are damaged.
Spare parts must comply with the standards and specifications laid down by the
manufacturer. Only use KUHN spare parts.
Before carrying out any electrical welding work on the tractor or towed machine,
disconnect the cables from the alternator and battery.
Check the tightness of screws and nuts regularly. Tighten up if necessary.
CONVEYOR CHAIN TENSION
To be checked every 100 hours. If the sag exceeds 150 mm, tighten up the chains (cf. diagram).
To tighten the chains:
- Remove the two guards (1) (see diagram below).
- Tap the plate (4) lightly to release the screws (3).
- Tighten the assembly with the nuts (5) screwed onto the tension device (2).
- Refit the guards (1).
- Never fully tighten the chains. Always leave at least 50 mm of sag.