Kugelmann K-TRONIC 2, Оригинальная инструкция по эксплуатации

Страница: 29 / 150

// ORIGINAL OPERATING INSTRUCTIONS
Commissioning 11/15/2016 29/150
1 Fit master (Pos. 10) at appropriate place in the carrier vehicle.
2 Fit connection box (Pos. 50) at an appropriate place outside the cabin (ideally close to
the hydraulic connectors).
3 Fix the 19 pin joint (Pos. 80) at an appropriate place in the cabin of the
carrier vehicle (ideally next to the master (Pos. 10)).
4 Lay BUS cable (Pos. 90) in the carrier vehicle to the connection box (Pos. 50) and connect
it.
Caution
Laying of BUS cable.
Danger of property damage.
•
Lay the BUS cable over the pivot of the cabin in order to allow the cabin to tilt.
Hinweis
The terminal diagram is located in the connection box (Pos. 50).
5 Connect white-red drive signal cable (Pos. 70) with the carrier vehicle.
6 Connect power supply cable (Pos. 60) with the battery (Pos. 100) of the carrier vehicle.
Caution
Connecting power supply cable.
Danger of property damage.
•
Please make sure that, in the positive cable, a fuse is attached as close to the
battery as possible (max. 15 A)!
7
Plug in the master cable (Pos. 30) at the rear of the
master (Pos. 10) and at the 19 pin joint (Pos. 80).
Pay attention to the marked protrusion!
8
Connect connecting cable (Pos. 40) at the connection box (Pos. 50).