Kugelmann K-TRONIC 2, Оригинальная инструкция по эксплуатации

Страница: 59 / 150

// ORIGINAL OPERATING INSTRUCTIONS
Commissioning 11/15/2016 59/150
7.13 Recommissioning
1 Recommissioning at the same carrier vehicle where the control system was
mounted before:
➯
In case of recommissioning at the same carrier vehicle after storage in
summer, repair work or maintenance work, it is not necessary to carry out
new settings.
➯
If a hydraulic component has been repaired or replaced, the sensors (see
Chapter
7.7 "Check and setting of sensors", page 43
) and the characteristic
curves (see Chapter
7.8 "Configuration of characteristic curves", page 45
)
must be recorded again.
➯
The operating unit has to be reassembled in the carrier vehicle and all cables
have to be connected (see Chapter
7.1 "Wiring diagram", page 27
).
2 Recommissioning at a new or different carrier vehicle :
➯
The operating unit has to be remounted in the carrier vehicle and all cables
have to be connected (see Chapter
7.1 "Wiring diagram", page 27
).
➯
The drive signal and the characteristic curves must be reconfigured (see
Chapter
7.6 "Configuration of drive signal", page 39
and Chapter
7.8
"Configuration of characteristic curves", page 45
).
Caution
Damaged power lines.
Risk of injury.
•
Damaged power lines have to be replaced immediately!
Caution
Maintenance work without necessary technical knowledge or appropriate tooling.
Risk of injury or property damage.
•
Only carry out maintenance work if you have the necessary expertise as well as
suitable tools!