Kubota ZD1211-60, Руководство оператора

Страница: 79 / 106

EVERY 200 HOURS
1. Changing engine oil
WARNING
To avoid serious injury or death:
• Be sure to stop the engine and remove the key
before changing the oil.
• Allow the engine to cool down sufficiently. Oil
can be hot and may cause burns.
1. To change the used oil, remove the drain plug at the
bottom of the engine and drain the oil completely.
The used oil can be drained out more easily if the
engine is warm.
2. Fill with the new oil up to the upper notch on the
dipstick.
(1) Drain plug
3. To check the oil level. Remove the dipstick, wipe it
clean, insert it and draw it out again. Check to see
that the oil level is between the 2 marks.
2. Replacing the engine oil filter
WARNING
To avoid serious injury or death:
• Be sure to stop the engine and remove the key
before changing the oil and the oil filter.
• Allow the engine to cool down sufficiently. Oil
can be hot and may cause burns.
The oil filter must be changed every 200 service hours.
1. Apply a slight coat of oil onto the rubber gasket of
new filter.
2. Tighten the filter quickly until it contacts the
mounting surface. Tighten filter by hand an
additional 1/2 turn only.
3. After the new filter has been replaced, the engine
oil level normally lowers a little. Add engine oil to
proper level. Check for oil leaks around filter gasket.
NOTE :
• To prevent serious damage to the engine,
replacement element of the recommended
type must be used. Use only a genuine
KUBOTA filter or its equivalent.
(1) Engine oil filter
3. Replacing transmission oil filter
(HST)
WARNING
To avoid serious injury or death:
• Be sure to stop the engine and remove the key
before changing the oil filter.
• Allow the transmission case to cool down
sufficiently, as oil can be hot and may cause
burns.
The oil filter must be changed every 200 service hours.
(1) Transmission oil filter (HST)
MAINTENANCE EVERY 200 HOURS
76
ZD1211,ZD1221