Kubota ZD1211-60, Руководство оператора

Страница: 31 / 106

4. Place the motion control levers in the “NEUTRAL
LOCK” position.
Neutral indicator will come on.
(1) Motion control lever (LH)
(2) Motion control lever (RH)
(3) Neutral indicator (A) “NEUTRAL LOCK” position
(B) “NEUTRAL” position
(C) “FORWARD”
(D) “REARWARD”
5. Set the throttle lever 1/2 way forward.
(1) Throttle lever (A) “FAST”
(B) “SLOW”
6. Insert the key into the key switch and turn clockwise
1 notch.
Make sure the Easy Checker
™
lights are on.
(See Key switch on page 29.)
WARNING
To avoid serious injury or death:
• Do not depress the hydraulic lift control
pedal.
When the engine is off, depressing the
hydraulic lift control pedal (UP or DOWN)
will lower the implement.
7. Turn the key switch clockwise, and hold it for about
5 seconds. (at the “PREHEAT” position)
For the appropriate preheating time, refer to the
table below:
Temperature Preheating time
Over 0
℃
(32
℉
) 5 seconds
Below 0
℃
(32
℉
) 10 seconds
(1) Glow plug indicator
NOTE :
• Glow plug indicator (1) comes on while the
engine is being preheated.
8. Turn the key switch to the “START” position and
release the key to the “ON” position when the
engine starts.
IMPORTANT :
• Do not use starting fluid or ether.
• To protect the battery and the starter, make
sure that the starter is not continuously
turned for more than 10 seconds.
• Do not turn the key switch while the engine
is running.
• When the temperature is below 0
℃
(32
℉
),
run the engine at medium speed to warm up
the lubricant of the engine and transmission
for at least 10 minutes. If the machine is
operated before the lubricant is warm
enough, the machine life will be shortened.
• Do not operate the machine under full load
until it is sufficiently warmed up.
• When the ambient temperature is less than
-15
℃
(5
℉
), remove the battery from the
machine and store it somewhere warm until
next operation.
9. Make sure that the Easy Checker
™
lights have
gone off. If the light is still on, immediately stop the
engine and check the remedy following the
instruction.
(See CHECK DURING OPERATING on page 29.)
10. Warm up the engine by running at medium speed.
OPERATING THE ENGINE STARTING THE ENGINE
28
ZD1211,ZD1221