Kubota B3300SU, Руководство оператора

Страница: 72 / 79

PERIODIC SERVICE 56
7. After running the engine for a few minutes, stop it and
check the oil level again; add oil to prescribed level.
8. After the new filter has been replaced, the
transmission fluid level will decrease a little. Make sure
that the transmission fluid does not leak through the
seal, and check the fluid level.
Top off if necessary.
9. Properly dispose of used oil.
A
To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
A
If the 3-point hitch can not be raised by setting the
hydraulic control lever to the UP position after long
term storage or when changing the transmission oil,
turn steering wheel to the right and left several times
to bleed air from the system.
A
Do not operate the tractor immediately after changing
the transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
B
Cleaning Transmission Strainer
When changing the transmission fluid, disassemble and
rinse the strainer with nonflammable solvent to completely
clean off filings.
When reassembling be careful not to damage the parts.
A
Since the fine filings in the oil can damage the
precision component parts of the hydraulic system, the
end of the suction line is provided with an oil strainer.
B
Replacing Fuel Filter Element
(See "Cleaning Fuel Filter" in "EVERY 100 HOURS" in
"PERIODIC SERVICE" section.)
(1) Oil inlet
(1) Strainer
(2) Suction line
(3) O-ring