Kubota B2401DT, Руководство оператора

Страница: 72 / 95

2. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to
see that the oil level lies between the 2 notches.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See LUBRICANTS, FUEL AND COOLANT on
page 59)
(1) Dipstick (A) Range which engine oil level
is acceptable within
(1) Oil inlet
IMPORTANT :
• If oil level is low, do not run engine.
5. Checking coolant level
WARNING
To avoid personal injury or death:
• Do not remove radiator cap while coolant is hot.
When cool, slowly rotate cap to the first stop
and allow sufficient time for excess pressure to
escape before removing the cap completely.
1. Check to see that the coolant level is between the
“FULL” and “LOW” marks of recovery tank.
2. When the coolant level drops due to evaporation,
add soft water only up to the full level.
In case of leakage, add antifreeze and soft water in
the specified mixing ratio up to the full level.
(See Flushing cooling system and changing coolant
on page 78)
(1) Recovery tank (A) Full
(B) Low
IMPORTANT :
• If the radiator cap has to be removed, follow
the preceding caution and securely retighten
the cap.
• Use clean, fresh soft water and antifreeze to
fill the recovery tank.
• If coolant should leak, consult your local
KUBOTA Dealer.
6. Cleaning evacuator valve
1. Open the evacuator valve to get rid of large
particles of dust and dirt.
(1) Evacuator valve
7. Cleaning grill and radiator screen
WARNING
To avoid personal injury or death:
• Be sure to stop the engine and remove the key
before removing the screen.
PERIODIC SERVICE DAILY CHECK
66
B2401DT, B2401DTWO, B2401DTN