Kubota B2401DT, Руководство оператора

Страница: 65 / 95

LUBRICANTS, FUEL AND COOLANT
No. Locations
Capacities
Lubricants
B2401DTN B2401DT B2401DTWO
1 Fuel 23 L (6.1 U.S.gals.)
No. 2-D diesel fuel
No. 1-D diesel fuel if temperature is below
-10
℃
(14
℉
)
2 Coolant (with recovery tank) 3.9 L (1.0 U.S.gals.) Fresh clean soft water with coolant and antifreeze
3 Engine crankcase (with filter) 3.1 L (0.8 U.S.gals.)
• For the engine oil, see the following Engine oil .
Above 25
℃
(77
℉
)
SAE30, SAE10W-30 or
15W-40
-10
℃
to 25
℃
(14
℉
to 77
℉
)
SAE20, SAE10W-30, or
15W-40
Below -10
℃
(14
℉
) SAE10W-30
4 Transmission case 12.5 L (3.3 U.S.gals.) • KUBOTA SUPER UDT-2 fluid
5 Front axle case
3.0 L
(0.8 U.S.gals.)
3.2 L (0.9 U.S.gals.)
• KUBOTA SUPER UDT-2 fluid or SAE 80-SAE 90 gear
oil
6
Greasing No. of greasing points Capacity Type of grease
Brake pedal 1
Until grease overflow.
Multipurpose Grease
NLGI-2 OR NLGI-1 (GC-LB)
Brake pedal shaft 1
Clutch pedal 1
Top link 1
Lift arm 2
Lifting rod (RH) 1
Universal joint 1
Range gear shift lever 1
Battery terminal 2
Moderate amount Lift arm ball joint 2
Lower link ball joint 2
NOTE :
• The product name of KUBOTA genuine UDT fluid may be different from that in the Operator's Manual depending on countries or
territories. Consult your KUBOTA Dealer for further details.
Engine oil
• Oil used in the engine should have an American Petroleum Institute (API) service classification and Proper SAE
Engine Oil according to the ambient temperatures as shown in the preceding lubricants, fuel and coolant.
• Refer to the following table for the suitable API classification engine oil according to the engine type (with internal
EGR, external EGR or non-EGR) and the fuel.
Fuel used
Engine oil classification (API classification)
Oil class of engines except external EGR
*
Oil class of engines with external EGR
*
Ultra low sulfur fuel
<0.0015% (15 ppm)
CF, CF-4, CG-4, CH-4 or CI-4
CF or CI-4
(Class CF-4, CG-4 and CH-4 engine oils cannot be
used on EGR type engines.)
* EGR: Exhaust gas re-circulation
• The CJ-4 engine oil is intended for DPF (diesel particulate filter) type engines, and cannot be used on this tractor.
Except external EGR With external EGR
Models B2401DT / B2401DTWO / B2401DTN －
Fuel
• Cetane number of 45 is minimum. Cetane number greater than 50 is preferred, especially for temperatures below
-20
℃
(-4
℉
) or elevations above 1500 m (5000 ft).
• Diesel fuels specified to EN 590 or ASTM D975 are recommended.
LUBRICANTS, FUEL AND COOLANT MAINTENANCE
B2401DT, B2401DTWO, B2401DTN
59