Kubota B2401DT, Руководство оператора

Страница: 84 / 95

2. Apply grease through the grease fittings of
universal joint.
3. Attach the plug and step mat back into position.
[B2401DTN only]
(1) Universal joint
(2) Plug (3) Grease fitting
Tightening tor-
que
Plug (2)
44.1 N
⋅
m to 53.5 N
⋅
m
(4.5 kgf
⋅
m to 5.5 kgf
⋅
m)
[32.5 lbf
⋅
ft to 39.5 lbf
⋅
ft]
[All models]
(1) Universal joint (2) Grease fitting
EVERY 800 HOURS
1. Adjusting the engine valve
clearance
Consult your local KUBOTA Dealer for this service.
EVERY 1000 HOURS OR 1 YEAR
• Be sure to do the following servicing once every
1000 hours or yearly, whichever comes first.
1. Replacing air cleaner primary
element and secondary element
(See Cleaning air cleaner primary element on page 72)
IMPORTANT :
• To prevent serious damage to the engine, use
only a KUBOTA genuine filter.
EVERY 1500 HOURS
1. Checking fuel injection nozzle
injection pressure
Consult your local KUBOTA Dealer for this service.
EVERY 2000 HOURS OR 2
YEARS
• Be sure to do the following servicing once every
2000 hours or biennially, whichever comes first.
1. Flushing cooling system and
changing coolant
WARNING
To avoid personal injury or death:
• Do not remove radiator cap while coolant is hot.
When cool, slowly rotate cap to the first stop
and allow sufficient time for excess pressure to
escape before removing the cap completely.
1. Stop the engine, remove the key and let it cool
down.
2. To drain the coolant, remove the radiator hose, and
remove radiator cap. The radiator cap must be
removed to completely drain the coolant.
3. After all coolant is drained, install the radiator hose.
4. Fill with clean soft water and cooling system
cleaner.
5. Follow directions of the cleaner instruction.
6. After flushing, fill with clean soft water and
antifreeze until the coolant level is just below the
radiator cap. Install the radiator cap securely.
7. Fill with coolant up to the “FULL” mark of recovery
tank.
8. Start and operate the engine for few minutes.
9. Stop the engine, remove the key and let cool.
10. Check coolant level of recovery tank and add
coolant if necessary.
PERIODIC SERVICE EVERY 800 HOURS
78
B2401DT, B2401DTWO, B2401DTN