Dok. Nr. R60744_Index 1a
Page 15 / 27
5.6.
Save Parameter
The „Save Data To…“‐ menu can be found as follows:
Safety Unit
Load Data From …
Edit Data / Save Data …
Display Unit
Edit Data / Save Data …
5.6.1.
Save Parameter to Safety Unit
The following storage locations are selectable for the safety unit parameters:
Select „Save Data To Safety Unit“ to save the respective
parameters in that unit. Then press OK to confirm.
Select „Save Data To Flash Memory“ to save parameters
of the safety unit into the flash memory of the SMCB.1.
Then press OK to confirm.
5.6.2.
Save Parameter to Display Unit
To save parameters in the SMCB.1, please select
„Save Data To Display Unit“ and press OK to confirm.
5.6.3.
Storage Hints
To ensure a correct storage, the procedure must be
confirmed with OK. The respective storage location is
shown in the info line of the display.
If the menu (after changing parameters) should be left
without saving, the procedure „Exit Without Save Press
OK“ must be confirmed with OK. Press button C to jump
back to the storage menu.
If the menu has been left without saving, the data are
not lost. They are still available in the menu „Use Loaded
Data“
(see chapter 5.4).
