BoWex
®
FLE-PA / FLE-PAC
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
40117 EN
15 of 17
3
Please observe protection
note ISO 16016.
Drawn:
2018-09-06 Pz/Hk
Replacing:
KTR-N dated 2018-08-30
Verified:
2018-09-06 Pz
Replaced by:
Table 12: Displacement figures
Size
Perm. axial displacement
K
a
[mm]
Perm. radial displacement
K
r
[mm]
Perm. angular displacement
K
w
[degree]
Type FLE-PA
48
± 2
0.3
± 0.9
T 48
± 1
0.3
± 0.7
T 55
± 2
0.3
± 0.7
65
± 2
0.3
± 0.7
T 65
± 1
0.3
± 0.5
T 70
± 2
0.3
± 0.6
80
± 2
0.3
± 0.6
T 80
± 1
0.3
± 0.4
100
± 2
0.4
± 0.6
T 100
± 1
0.4
± 0.4
125 / T 125
± 2
0.5
± 0.4 / ± 0.3
Type FLE-PAC
48 / T 48
± 3
0.3
± 0.9 / ± 0.7
T 55
± 3
0.3
± 0.7
65 / T 65
± 3
0.3
± 0.7 / 0.5
80 / T 80
± 3
0.3
± 0.6 / ± 0.4
100 / T 100
± 3
0.4
± 0.6 / ± 0.4
125 / T 125
± 3
0.5
± 0.4 / ± 0.3
Before start-up of the coupling, please inspect the tightening of the setscrews in the hubs, the alignment and the
distance dimension l
3
or l
7
and adjust, if necessary, and also inspect all screw connections for the tightening
torques specified.
Finally the coupling protection against accidental contact must be fitted. It is required in accordance with
DIN EN ISO 12100 (Safety of Machinery) and must protect against
access with the little finger
falling down of solid foreign objects.
The cover may provide for openings intended for necessary heat dissipation. These openings have to comply with
DIN EN ISO 13857.
The cover must be electrically conductive and included in the equipotential bonding. The cover may only be taken
off with standstill of the unit.
During operation of the coupling, please pay attention to
different operating noise
vibrations occurring.
!
If you note any irregularities with the coupling during operation, the drive unit must be
switched off immediately. The cause of the breakdown must be specified by means of the
table „Breakdowns“ and, if possible, be eliminated according to the proposals. The potential
breakdowns specified can be hints only. To find out the cause all operating factors and
machine components must be considered.
4
Assembly
4.8 Displacements - alignment of the couplings
5
Start-up
