KTM Freeride E-SX, Руководство пользователя

Страница: 5 / 30

When using the KTM PowerPack for the first time, the vehicle must be ridden until the KTM PowerPack is fully dis-
charged. The vehicle will initially reduce its output power. It can be operated in this power-reduced state for several min-
utes before the drive switches off altogether. Then charge the KTM PowerPack until the charger completes the process at
100%. The status and charge state displayed on the charger indicate the progress. Charging can take up to four hours. Do
not skip this procedure as it has a significant influence on the performance of the KTM PowerPack.
The vehicle contains a high-voltage battery
1
(the KTM PowerPack,
260 V) and a 12-V battery
2
. The 12-V battery is located under the seat.
Next to the 12-V battery there is a fuse box
3
with two fuses.
The KTM PowerPack is located under the seat and is screwed onto the
electric motor. The KTM PowerPack can be removed in just a few steps.
The KTM PowerPack can be charged while it is installed in the vehicle
or outside of the vehicle. Check the KTM PowerPack for damage to the
housing or connector every time it is removed and reinstalled.
The 12-V battery is necessary to operate the vehicle. The vehicle control
unit requires the 12-V battery to start the system. If the 12-V battery is
faulty, discharged, or disconnected, the vehicle will not start.
2.1 Power supply
2.2 New KTM PowerPack
To protect the KTM PowerPack, the motor control unit reduces the power at low temperatures.
When the temperature of the KTM PowerPack drops to below 8 °C, the motor control unit reduces the power to 80%. Be-
low 0 °C, 50% of power remains available. In both cases, the active drive mode indicator flashes slowly. The vehicle can
continue to be operated. The KTM PowerPack is not damaged by the reduction in power.
The KTM PowerPack warms up during vehicle operation. When the temperature of the KTM PowerPack rises above 0 °C,
power is restored to 80% after the vehicle is restarted. When the temperature of the KTM PowerPack rises above 8 °C, full
vehicle power is restored after the vehicle is restarted.
2.3 Operation at low temperatures
This vehicle requires a special coolant because the cooling unit contains copper parts. Never use conventional, commer-
cially available coolant as it will cause corrosion. Only use the coolant specified here.
KTM Special Antifreeze Ready Mix E-Bike (00062020205)
2.4 Coolant
2 IMPORTANT NOTES
4