KTM Freeride E-SX, Руководство пользователя

Страница: 22 / 30

8.2 Troubleshooting of the charger
Fault Blink
code
Measure 1 Measure 2 Measure 3
Fault in the charging
cable
11 Check the charging plug and
charging cable for external dam-
age and reconnect
Contact an autho-
rized KTM workshop
Fault in the charging
cable
12 Check the charging plug and
charging cable for external dam-
age and reconnect
Contact an autho-
rized KTM workshop
Fault in the charging
cable
13 Check the charging plug and
charging cable for external dam-
age and reconnect
Contact an autho-
rized KTM workshop
Overtemperature of the
charger
51 Let the charger cool down Resume charging in
a cooler location
Contact an authorized
KTM workshop
Fault in the supply
voltage
63 Use the "Normal" charge mode Choose a socket
closer to the central
supply
Contact an authorized
KTM workshop
Fault in the supply
voltage
65 Use the "Normal" charge mode Choose a socket
closer to the central
supply
Contact an authorized
KTM workshop
- Read out the fault.
- Switch off the charger.
- Wait 15 seconds.
- Remedy the fault as instructed in the table.
- Switch on the charger.
Important
For all faults that are not listed in the table, switch the charger off and on again. If this does not eliminate the fault, con-
tact an authorized KTM workshop.
If LED
1
flashes, there is a charger fault.
All of the following blink codes are displayed on the charger
and refer to the charger itself.
The pause between the signal of the 1st digit is 0.25 seconds.
The pause between the 1st and 2nd digits is 1 second.
The pause until the blink code repeats is 3 seconds.
The following example shows blink code 31:
21
8 TROUBLESHOOTING