KTM 690 LC4 2007, Руководство по ремонту

Страница: 28 / 95

4-9
3
4 4
5
6
7
8
9
– Hold the primary pinion with special tool 750.29.081.000
1
while
you unscrew and remove the nut (A/F 27 mm).
NOTE: LH thread!
– Pull the anti-hopping clutch disks out of the outer clutch hub with
special tool 750.29.033.000
2
.
NOTE: the stepped disk mounted underneath usually sticks to the
clutch hub.
– Remove the stepped disk
3
.
– Take the half disks
4
out of the groove.
– Remove the outer clutch hub, needle bearing
5
and the washer
6
mounted underneath.
– Remove the pressure piece
7
and the pushrod.
– Mount special tool 750.29.021.000
8
on the primary pinion
9
and hold (A/F 24 mm) while you turn in the screw (A/F 19 mm); this
will pull the primary pinion off the crankshaft.
1
2