KTM 450 XC-W USA, Инструкции по установке

Страница: 17 / 31

3 WORK
15
K00073-10
–
Mount and tighten screws

.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Finishing work
–
Refit the headlight mask with the headlight. ( p. 9)
–
Check the headlight setting. ( p. 10)
3.12 Removing the seat
101346-10
–
Remove screw

.
–
Lift up the seat at the rear, pull it back and then remove it from above.
3.13 Mounting the seat
K00075-01
–
Mount the front the seat on to the collar bushing of the fuel tank, lower it at the
rear and simultaneously push it forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixing.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
3.14 Installing the battery
H00383-10
Main work
–
Insert the battery into the battery compartment with the terminals facing forward.
Battery (YTX5L-BS)
–
Reconnect rubber band  .
–
Position positive cable

and mount and tighten the screw.
Guideline
Screw, battery terminal M5 2.5 Nm
(1.84 lbf ft)
Info
Contact disks

must be mounted under screws

and cable sockets

with the claws toward the battery terminal.
–
Slide positive terminal cover

over the positive terminal.
–
Position negative cable

and mount and tighten the screw.
Guideline
Screw, battery terminal M5 2.5 Nm
(1.84 lbf ft)
Finishing work
–
Install the air filter box cover. ( p. 17)