CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. shall safeguard its rights to the full extent of the law.
USER MANUAL AND INSTALLATION
COD. 091052 - REV. 07 - DATE 11/2016
Pag.23 di 45
6.5
CONNECTION AND START UP
6.5.1
GENERAL WARNINGS
At first start up the machine and check that:
- The supply voltage corresponds to that indicated on the label.
- The sizing of the main switch on the wall, must follow the instructions of the technical data
table (see section 6.6.1).
- Check for proper oil level (see section 11.3).
- The electrical connections are made using cables of appropriate size (see section 6.6.3)
ATTENTION!
Carefully follow the SAFETY PRECAUTIONS on the use of the machine.
For the European market tanks are built in accordance with Directive 87/404/EEC,
while the compressors are built in accordance with Directive 98/37/EEC.
Check your model on the data plate on the compressor and the beginning of this
manual.
6.5.2
CONNECTING OF THE POWER CABLE OF COMPRESSOR
Plug the power cable through the cable gland and follow the path indicated by the red arrow as
shown in the figure below:
ATTENTION!
To connect the wires in the correct plug terminals, follow the electric scheme in
Cap. 8.1