CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. shall safeguard its rights to the full extent of the law.
USER MANUAL AND INSTALLATION
COD. 091052 - REV. 07 - DATE 11/2016
Pag.6 di 45
1.2
RULES APPLY
As expressed in the declaration of conformity (chap. 1.1.1), the air compressor is identified by the
label on the front of this document complies with the essential requirements of DIRECTIVE - LAW
2009/105/CE - 2014/35/CE – 2006/42/CE – 2014/30/CE - EN60204-1 - EN1012-1
1.3
GENERAL INFORMATION
The compressor should be used only as indicated in this manual, which should be stored carefully in
a place easily accessible and familiar, since it will follow the entire life of the machine.
For any requests always specify model and serial number.
1.3.1
WARNINGS AND PRECAUTIONS
Before each operation, read carefully this user manual. Failure of the information and instructions
contained in it can cause damage to property and injury to persons.
• The machine was designed and built for the following functions. Any other commitment is not
allowed.
• Installation and maintenance must be performed by qualified personnel. Always follow the safety
rules.
• The manufacturer disclaims any liability for damage to persons or things to the machine in
question, caused by incorrect use of the same, failure or superficial compliance with security
policies in this manual, by even slight changes, from use of
non-original spare parts
.
1.4
HOW TO SEE THE MANUAL
Symbols have been identifying situations requiring extra attention. These symbols may appear next
to a text, a picture next to or on top of the page. Give full attention to the meaning of the symbols:
their function is to avoid repeating the key terms or notices of darkness, to be considered
"reminders". See the page below whenever doubts arise about their meaning.
WARNING: This highlights an important description regarding hazardous
conditions, safety warnings, information of utmost importance.
MACHINE STOPS: Each operation must be performed with the machine stopped
ATTENTION MACHINE IN PRESSURE: every operation must be performed for a
machine without pressure in the air/oil separator tank (0 bar).