CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. shall safeguard its rights to the full extent of the law.
USER MANUAL AND INSTALLATION
COD. 091052 - REV. 07 - DATE 11/2016
Pag.26 di 45
6.7
AIR CONNECTION OF COMPRESSOR
Be sure to use compressed air tubing with features and cross section appropriate to the
compressor. Do not repair a faulty tube, but proceed with the replacement.
Connect the compressor to the pneumatic network by using the special attack female 3/8" arranged
on the compressor and illustrated.
We recommend using a pipe with a diameter equal to or greater than the output of the compressor
3/8 ".
It is recommended during installation to connect a ball valve between the air tank and the line as
indicated above, (if not present in the supply).
Attention! The compressor does not require not-return valves because it is already
installed within. The valve mounting could cause incorrect operation of the
compressor.