8
Id.: 17-16-26-3017-03 | 6.2017
Electrical installations have to be inspected in accordance with regulations on
the requirements for low voltage electrical installations in buildings by the
installer of electrical installations.
DANGER
Connecting the devices power cable can be performed by a qualified
electrician. During the procedure the device must not be live.
WARNING
In case the power cable of the device is damaged it has to be immediately
replaced. The replacement can only be performed by the installer or
authorised maintenance worker.
WARNING
Before opening the device disconnect all electrical circuits and make sure the
device is not live.
CAUTION
Putting any kinds of items on or next to the device is prohibited.
CAUTION
In case the device is placed on the ground which is more subject to the
transfer of vibrations than a classical concrete panel with a screed, it is
necessary to underlay the device with a suitably thick and quality anti-vibration
underlay.
CAUTION
The device must not be placed in a room where it cannot be removed. Later
walling or setting up of other obstacles next to the device is forbidden.
CAUTION
In three-phase versions of the device it is necessary to ensure the correct
arrangement of phases when connecting it to the power supply.
CAUTION
For the correct operation of the device, the electrical distributor has to provide
electricity of adequate quality (SIST EN 50160). In normal conditions this is
within ± 10 % of the rated voltage. The data about the state of the electrical
grid have to be acquired from the electrical distributor.
CAUTION
Operation of the device with a frequency converter is forbidden.
CAUTION
Connecting the device to the electrical network has to be performed in
accordance with the standards for connecting devices to the electrical
network. Connect the device to the electrical network via the power supply
cut-off which is installed into the electrical installation under the regulations in
force.
