Krone Comprima CF 155 XC, Оригинальная инструкция по эксплуатации

Страница: 342 / 384

Malfunctions - Causes and Remedies
342
Pos: 63.5 /Überschriften/Überschriften 2/A-E/Allgemeine Störungen @ 24\mod_1241775122213_78.docx @ 248807 @ 22 @ 1
16.1 General malfunctions
Pos: 63.6 /BA/Störungen - Ursachen und Behebung/Rundballenpressen/Tabellarische Auflistung Allgemein CF/CV @ 290\mod_1410330051969_78.docx @ 2288987 @ @ 1
Malfunction Possible cause Remedy
Pick-up cannot be
lowered.
Hydraulic hose not plugged in. Insert hydraulic hose into the appropriate
coupling.
Clamping pressure
does not build up Handwheel is in parking position Screw in handwheel completely
Screw out handwheel for baling
pressure Set handwheel for baling pressure to the
desired pressure
Blockages in the feed
area. In case of
blockages, stop
immediately and turn off
the PTO shaft as the
floor conveyor strips
can be damaged
otherwise.
Remove blockages. Swaths are of uneven height or too
large. Split swaths.
Driving speed too high. Reduce driving speed. Slow down at the
beginning of the baling process until the
picked up crop rolls into the bale
chamber.
The machine is not hitched
horizontally. Hinge machine higher at front; adjust
drawbar height so that the transition from
pick-up to channel is more even.
The baffle sheet moves upwards. Remove the spring completely from the
baffle sheet.
The transfer of short
crop from the pick-up to
the cutting roller is
inadequate. The machine is too low at front. Hinge the machine higher at front, adjust
drawbar height so that the transition from
pick-up to channel is even.
The floor conveyor
takes forage up The inner bale core is set too tight Adjust the soft core or reduce the baling
pressure.
In case of barrel-shaped
bales, the wrapping
material tears in the
middle.
The bale chamber is not filled
evenly. Drive over the swath on alternate sides.
The number of wrappings is too
small. Increase number of wrappings.
Net brake is too tight. Loosen net brake.
Net spreader is set too tight. Adjust spreading device.
Floor conveyor switches too late Change switching time.
Bale is formed conically. The bale chamber is filled on one
side. Make sure when baling that the bale
chamber is filled evenly. Slow down
especially at the end of the bale.
Speed is too high at the end of
baling process. Slow down at the end of the baling
process.
Twine or wrapping material torn. Just use twine or wrapping material in the
provided quality.
The number of wrappings is not
sufficient. Wrapping material
loosens. Set the twine tying device to a closer tying
distance or increase the number of
wrappings of the wrapping material.