KROMBACH TUFSEAT Performance Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 14 / 28

www.cranecpe.com
14
1. Apply castrol optimal paste on short threaded part of the
studs (#10) and insert them into the body tap holes. Then
tighten the studs.
2. Insert SX stem seal (#7) over the top of the stem (#4) with
the conical surface facing the spherical stem shoulder (see Fig.
1), slide the SX seal over the spherical portion of the stem (see
Fig. 2).
Figure 2 Figure 1
3. Insert stem (#4) through the valve body cavity, allowing
the SX seal (#7) to be seated into the body counter bore.
(see Fig. 3).
4. Place the spring energized lip seal (#12) (Fig. 4a) over the
stem (#4) with the spring side facing downward into the
body (as shown in Fig. 4b) and gently push into position
(below the packing chamber).
5. Install the support ring (#9) over the stem (#4) with the
raised step facing downward until it locates at the bottom
of the packing chamber. (See Fig. 5).
KFO1176: Standard Trim
Assembly of KFO-1176 Standard Trim Floating Ball Valve
Figure 5
Stem #4
Guide Bushing #14
Packing Gland #8
Packing #13
Support Ring #9
Spring Energized Lip
seal #12
SX Stem Seal #7
Figure 4b
Figure 4a
Figure 3
Assembly of KFO-1176 Standard Trim Floating Ball Valve