3
INSTALLATION
18
OPTISYS TUR 1060
www.krohne.com
01/2019 - 4007152501 - MA OPTISYS TUR 1060 R01 en
3.4.4 Connecting the hoses
The scope of delivery contains two tubings with fittings (intake tubing, drain tubing) for the
connection between the flow-through unit and the flow intake and flow drain. The intake tubing
has a shut-off clamp and the drain tubing has a backpressure valve. Connect the hoses
according to the following drawing:
The hose for the connection between the sampling point and the device as well as the hose for
the flow drain do not belong to the scope of delivery. For this purpose use hoses with the
following specifications:
•
1/4 inch OD flexible tubing
•
Opaque hose material to prevent algae growth if direct sunlight can reach the hose.
CAUTION!
Do not connect the sensor interconnect cable with the upper part of the device now and regard
the installation order in the chapter "Electrical connections"! The reason is that you will have to
do the internal wiring at first and the connection of the sensor interconnect cable afterwards, the
reverse order could damage the device!
Figure 3-3: Connecting the hoses
1
Intake tubing with shut-off clamp
2
Drain hose with backpressure valve
3
Sensor interconnect cable
INFORMATION!
To prevent that the drain water causes any damages, assure that the drain hose leads to a
suitable drain site.
